DreamMapper Connection Guide Page 9
DreamMapper Bluetooth Connection - Internal Bluetooth on Board Device
Pair Bluetooth Device on DreamStation PAP Unit
Mobile App will display "Your therapy device has built-in support for Bluetooth..."
Make sure CPAP machine is plugged in, but not blowing air
Exit DreamMapper
Verify Bluetooth in mobile device is on: In the mobile device: Settings > General > Bluetooth (May need to
turn Bluetooth off and back on to attempt connection)
PRBT ### will appear in the list of devices. Click on this connection
Compare the codes displayed on your therapy device and this mobile device.
If the codes match, confirm on both devices to complete the pairing process. (Click pair on both PAP unit
and mobile device) The mobile device should now indicate that your therapy device is "Connected"
Once connected, open DreamMapper app and enter the settings menu
Click on Data connection and click the blue or green button to the right of Choose Bluetooth
On the Bluetooth page scroll down and click Begin Using
The sync should count to 100% Then data will be available for viewing on Sleep tab
Please begin each day by launching DreamMapper so that it can synchronize with your therapy device.
Remember that this can succeed only if you are in the same room as your therapy device.
Although your therapy device may contain data that precedes the creation date of your DreamMapper
account, that data will not be shown in DreamMapper
For any additional troubleshooting, please contact the homecare provider or contact DreamMapper
DreamMapper Modem Connection
If there is a modem on your PAP device, the data should automatically be transmitted between the sleep
therapy device and DreamMapper.
If data is not displaying on MyDreamMapper.com, contact the homecare provider and ask them to enter
the following information into EncoreAnywhere patient profile:
The email address used to register DreamMapper account
The device serial number used to register DreamMapper account
Modem Data Upload – System One PAP Unit
If all information is entered and data is not displaying in DreamMapper, follow these steps:
Unplug CPAP machine
Take off modem, leave off for 10 – 15 minutes
Place modem back onto CPAP machine